Building a soarer Part 1
So as it stands I'm building up my present car, the good old beefy Toyota Soarer (as stock 1600kgs <- OUCH) the lofty and lazy monster that it is.
The aim is to at least latch onto 300rwkw in the end and thus far the parts list is as follows
Modifications Purchased:
Modifications Purchased:
Work vs-xx (18x9 + 18x10)
Lowered
Pod Filter
Fmic 600x300x76
Custom High mount
Custom 3 inch dump + front
HKS/Garret - T04e
TurboSmart - Boost Controller
Turbosmart - Bov Kit
Turbosmart - Type II Sleeper series bov
Trust/Greddy - Cam Pulley
Trust/Greddy - E-Manage - Blue
Trust/Greddy - E-Manage - Harness - JZZ30
Trust/Greddy - E-Manage - Boost Pressure - Sensor - 3.kg/cm2
Trust/Greddy - Oil Catch Tank 1000 19mm hose
Trust/Greddy - Lightened Racing Pulley Kit
Hks 264 cam IN
Hks 264 cam EX
HKS DLI Ignition Amplification
TRD Thermostat
Next:
-Blitz Nur Spec Exhaust (Rampant)[Eta Unknown]
-Trust/Greddy - Profec E 01 (Nengun)[Processing]
-Oil Cooler [Sourcing]
-Trans Cooler [Sourcing]
-Walbro Fuel Pump [Sourcing]
-Bigger injectors [Sourcing]
Planned:
Mv Automatics Stage 1 or 2 and a Stall converter
Supra stick v4
Lightened Crank Pulley
New Plugs/Coil Packs
DBA Rotors
Line locker
Getting a new radiator and hoses.
How the Poor Engine Looks now
The new turbo on top of the old
When the turbo went bang, so much oil dumped down to the ic piping that I could probably bathe in it, that metal hose joiner (seen above) is stainless steel….
FMIC
FMIC
The fmic that arrived this morning
The Bov adapter and type Two Sleeper series Bov
[Enlarge] basic loom, being replaced by a full one
[Enlarge] Lightened Acc Pulleys
[Enlarge] Cam gear for exhaust side
[Enlarge] Piggyback ecu
[Enlarge] 3 Bar map sensor
